AC700F Modbus TCP/IP communication with Panel 800 (PP845)
I'm trying to set up a Modbus TCP/IP communication between AC700F controller (PM 783) and Panel 800 (PP845) but unfortunately i have some problem. I watched the video which explains how to configure a Modbus TCP/IP communication between AC900F controller and Panel 800 but in this video he is using Panel Builder Ver. 6 and I'm using Panel Builder 5.1 (I can't use Panel Builder Ver. 6 because PP845 is not supported). So, I tried to configure the AC 700F controller as slave and panel 800 as master but in Panel Builder 5.1 I can't specify the Port number and the Slave Node number (respectively 502 and 255) as you can see in the Figure 1 attached. So, I tried to configure the AC700F controller as Master and the PP845 as Slave but for some reason the connection is not established correctly as you can see in the Figure 2 and Figure 3 attached (in these pictures you can see the Modbus TCP/IP Diagnosis in Control Builder F). Controller and panel 800 are connected through a switch but I don't think this is a problem. Thnaks in advance.
Insert the URL that your highlighted text will link to.
Copy the video's "embed" tag into Embedded Video below.