Answer question
Why cm 574 communication module configuration error comes continuously
when i installed cm574 communication module, plc immediately going to stop mode . suppose i removed this module it going to run mode .
1) by codesys i given run mode it doest go why ?
2) all kind of reset options tried. but error comes immediately...?
3) what is the reason behind this issue?
4) any seperate procedure is there for this module to configure?
my software-control builder 2.3
communication-modbus rtu
plc-pm573 eth
i have enclosed some images for your refference .
can any one explain about this issue....? also give me the solution
thanks in advance
