Graphics Dispaly DigiVis
i want to Resize my Graphics Display to 1920-1080
The problem i am facing is that in the Control Builder F Graphics Display its showing me very Limited Space for the Graphics to Draw
Answer to question comment first,
Yes It is possible to customise predefine desplay size in graphic display, go to Options > ruler > choose required size.
Back to main question. you are right may be it's limited space as via ruler maximum you can define 1600x1200. so you must be getting vertically limited space for drawing!
most probably you are trying to draw a graphic display using the physical coordinates 1920 x 1080 in the graphics editor. That's why you will have a small place to draw. The GED uses a virtual coordinate system which is much bigger than the physical coordinate space.
If you want to create a picture for a a wide screen resolution 1920 x 1080, you should manually draw a horizontal line, which will be the lower boarder of your graphic display.
Have a look at the attached document to see, where to draw that line.
Hope that helps.
P.S.: We are working on a GED version that will support wide screen natively.