Analogue indication not shown on Engine 1Faceplate of 800XA while on other engine is ok
As you can see in the attached file the NH3 analogue indication for engine 1 is not visible (see page 1). For the other engines the same indication is ok (see p.2).
When we open Control Builder and go online to the emissions tab for engine 1 (the problematic one) we can see that there is indication of NH3 (see p.3).
On the other (healthy) engines when you Right click on the NH3 value and select Edit it takes you to the tab where you can see the signal current value with 2 decimals (see p.4 & 5).
On engine 1 when you Right click on the NH3 value and select Edit it takes you to the tab shown at p.6. No analogue value can be seen here.
Can someone please look into the attached pictures and tell me why we cannot see the NH3 on engine 1?
Thank you in advance.
This question has not yet been answered.