Trend of digivis not show
I can't show trend in digivis of my project but other project It's can show.
I set time syn. already. and I show you of logger on digivis in attached file
I have a doubt on digivis station time is in synch! Because from attached screenshot the digivis station shows weird time check image here from your screenshot
Pls note that timesynch should be enabled on all Digivis station, If timesynch enabled via configure tool and digivis station frame was open/running you need to close/stop digivis once and reopen again.
Then have you performed set system time from cbf ?
Open any controller web browser and check which controller is time master in network and also check time, is it showing correct time ? If not from cbf commissioning mode select time master controller resource, go to options, set system time and enter/set correct time there and say ok. this should solve your issue.
Also make sure your subnet must be 255.255.240.0 for timesynch.