Need help for Ethernet communication to PM554
I have PM554 ETH CPU. Now I want to connect my CPU to Automation Builder using Ethernet IP. I am trying to Scan the IP throuch Automation Builder but it is unable to scan any CPU.
I also want to Factory RESET the PM554 CPU. The procedure I followed to reset is
1. Power off cpu.
2. Keep DIP switch on STOP mode.
3. Power on CPU again.
4. Wait until Run LED stops blinking.
I have tried this. But after Power on RUN LED keeps on blinking. And I am unable to RESET the cpu.
So provide the RESET procedure.