Update of SignalInReal when change has been made in Control builder Hw-editor
Hi,
Why doesn't the SignalInReal faceplate update the values when changes has been made
in Control builder Hw-Editor?
In the hardware editor I changed the min- /max range from 0-20 to 0-40 and made a download to the controlller, but the change doesn't occur in the faceplate, it still shows the old 0-20 range.
see attached files.
Regards runsac
Voted best answer
Hi,
A change in properties on an I/O must also be followed by a change (Eg:dummy change) in the application to get the change in the faceplate.This is by design.
Answers
Can you go online and check the unit status tab for the AI card and share the screen shot?
Add new comment