AC500 Communication with freelance 2016
Hi,
Dear experts, can we communicate AC500 PLC (PM583-ETH) with Freelance 2016 as a SCADA application. if yes please! give me possible solutions.
Thanks.
Answers
Hello,
yes we can :-)
Please have a look at the attached file. It describes what to do.
If you currently are using DigiVis 500, then let me know. There is another document describing how to evolve from there.
Hope that helps.
Dieter Henkel,
Its very kind of you to reply. I have been successfully executed as per the manual said, attached in your earlier reply ( Freelance to AC500). But there is just one problem, (.SDB) file is not made because i am in simulation mode. I was wondering if there is something we can to do successfully execute simulation. Attached picture refers my error.
Regards
Arslan
Its very kind of you to reply. I have been successfully executed as per the manual said, attached in your earlier reply ( Freelance to AC500). But there is just one problem, (.SDB) file is not made because i am in simulation mode. I was wondering if there is something we can to do successfully execute simulation. Attached picture refers my error.
Regards
Arslan
Arslan Junaid,
If you don't have physical CPU, you cant use SoftPLC software.
Via this software you can simulate OPC items as well.
Hope it helps you.
Add new comment