Missing PLC Object in plant explorer
Hi, I am trying to use Plant Explorer to create Process Graphics for my PLC program. After some research, I understand that you need to create process object for signals you wish to represent graphically. I have tried to create these process object but have the following problems:
When I am trying to create a new Process Object type
System 800xA PLC connect Configuration (system version 5.1) chapter 2, pg. 17
IndustrialIT 800xA – System PLC Connect Configuration (system version 4.0) chapter 3 pg. 41.
But I have no green PLC object called PLC Object in my plant explorer.
I have also tried to create a new Control Network object
System 800xA PLC connect Configuration (system version 6.0) chapter 2, pg. 16.
But in my New Object dialog box I have nothing named PLC Generic Control Network.
Could you pls advise if there is something I am missing? Or am I going about this the wrong way?
Thanks for any answer.
With kind regards
Pls see attached picture of the extentions I am not able to load. The error msg. dosent say anything about why. Essentially I am trying to do what this video show,
Any help in achieving this whol be very appreciated.