PG2 Graphics Display Save Failure
Hi All,
if I try to edit a PG2 graphic display after a Logover
on an 800xA Operator Station I am able to modify a PG2 graphic
but I cannot save it at all, getting an exception error.
The Logover user that I impersonate has engineering permissions
and works fine if I use it to logon the Operator Station at startup.
This problem happens both in 800 xA 5.1 rev. A and 800 xA ver. 6.0.2
Regards
Paul.
Answers
Dont use logover for editing graphics.
Logover works fine for operating the plant. Its not so good for doing engineering tasks.
Add new comment