Delayed alarm update in 800xA system
Could you please check below?
Through MB300, AC450 has been used in 800xA system.
In this system, there are three of AS and two of CS.
Problem is that the alarms occured from AC450 are updated on 800xA 20~30mins later.
Please advise me where should I check to fix out this delayed updating problem.
Voted best answer
If time is correct, next thing to check for is system messages at RTA and controller. Iterate network with Control Builder A (OnLine Builder) and/or RTA Board Config tool.
Take notes of any system message you encounter, please be specific down to every detail.
Also remember to turn on system messages to screen and log in ONB settings.
Few months back self also faced same error
What is the xA system version?
I ve problem in SV4.1,
We tried like this our servers are located in different areas.we suspect this can be the network problem then we removed the problem server cs2 to the area cs1 and we restart by connect all cable
Then we solved this problem
You can search my problem below in the same fourm
800xA SV 4.1 Alarms are appearing after delay time