PM861 Fault during IP configuration
I have download firmware in the controller successfully but in IP config tool it gives blinking fault LED and does not connect after I Press reset. IP config tool detects System Reset but after that it times out and doesn't connect and fault led blinks.
Voted best answer
Greetings,
There are some terminators exis like TM850 CEX-bus terminator or TB852 RCLink terminator.
Did you put these terminators?
Hope it helps you.
Answers
1. Try removing battery
2. Record what is output on port #4 after a reset (connect with cable & HyperTerminal or PuTTY)
Add new comment