Having problem in AC800M Redundant CPU IPConfig?
I am site and here the IP Series for the AC800M controller is:
I changed the IP address of the controller by using IPConfig tool and downloaded the application with the secondary network configuration but unable to activate the secondary network.
In IPConfig Advance option I select the set backup CPU IP Address and set the Ethernet2 IP by "Default Rule".
Any one can help...
Voted best answer
To confirm the IP are set properly,please check the network Interface are captured in controller log files;
Also check the controler log files to find any errors regarding the CN2 Port.
Please check all the parameters are configured for "Ethernet 2" port under PM controllers in CBM and also check whether you are able to ping the secondary port (CN2) using cmd prompt.
Check secondary path is up or not (Up,Up) in RNRP for the controller.
Please check these points which may give you the hint.
Through IP Config tool, From Advanced option set IP of Primary.
Then goto Control builder and do the following settings
1) In Your First Ethernet Channel enter IP(10.120.100.X) & subnet mask.
2) In Second Ethernet channel enter IP(10.121.100.x) & subnetmask
3) In Second Ethernet channel, you will find a Parameter "Enable ethernet Channel". Make this to True.
Through this setting eventhough your 10.120.100.x series Switch fails/connection down, Controller will be pinging through the same 10.120.100.x IP but through 10.121.100.x.
Hope this helps..