Saving SNTP Primary IP address in REF&REM615 Relay
The SNTP Primary IP address in REF615 and REM615 series relay are pretty much the same as for any other relay.
You can set it through the HMI , by going to
Main menu/Configuration/Time/Synchronization/Synch source
You have to set the time source by up or down arrow and then it will ask for confirmation.
When you confirm it must be saved and will not change until you do a software reset.
I am aware of the procedure how to set the IP. Please go through the attachment after enquiring with support line reason was found due to Dataset Error (24) it will not hold the IP once relay get restarted.
Ultimately time sync never works.
Expecting solution to eliminate this "Dataset Error (24)". Reason also found this is due to configuration error.
How to solve this "CONFIGURATION ERROR" then only Data set Error will get out from Relay?
Source: Relay Dataset Error