CM50 Modbus TCP communication, IP setting Eth board setup
I have CM 50 unit,
Model : CM50/1DOSOEO/STD
Serial : 3K210000037655
Date : 18-06-2012
HW version : 1
SW version : P2/00.01.10
I want to communicate CM50 with AC 900F controller over Modbus TCP. For that I have replaced Eth board with CM Modbus board in unit. And tied up RJ45 connector at pins 19 to 23(Comms port) . Now when I power up unit I do not get any option under communication setting to set IP address. Only Modbus option is appearing. Is it problem of HW or SW version compatibility for Ethernet board ? or Am I missing something here to get Ethernet board active ? how to get IP address setting options?
For more details attached here with some images.
Voted best answer
Got the answer,
Usually by replacing ethernet board it should get activated and under Communication > Ethernet > IP setting related options get appear, incase it's not activated contact support people they can activate via service option. In my case it was activated via service option.