Hi,
Comapct HMI supports Modbus Serial Protocol and it has inbuilt driver for it. Configure AC500 as Modbus Serial Slave and use the above driver to establish communication with CHMI and AC500. Hope it helps you to start with the interface.
Comments (3)
New comment
How the addressing in CHMI5.1 for Modbus?
Rank: 11
on
10/21/2013 12:36:19 AM |
Like (0)
|
Report
Refer the following thread for PLC Modbus addresses
http://www402.abbext.com/communication-ac800m-pm856-ac500-pm571-modbus-q30305.aspx
Thank you very much for your help sir.
But what will be the addressing in CHMI5.1 according to PLC address %MD0.0
Add new comment 
Application Knowledge Store (AKS) will no longer be available after the 31 July 2021.
We are enhancing our Customer and Partner experience and will be migrating data from AKS to the new portal.
During the transition please direct your questions to:
If you are an ABB customer with a CARE Agreement you can access our Customer Portal, where you can find solutions and ask questions, and communicate directly with ABB.
If you are not an existing CARE customer with ABB please contact your local ABB sales office.
For our authorised Partners you can directly access additional support information in the Partner Portal
Add new comment