Hi,
Does anyone have a manual or tutorial for the SFC editor in CBF besides the editor's help?
Thank you
Hello,
Find attached here with manual for SFC programming from freelance_IEC 611313-3_Programing manual. Hope it helps to you..
Comments (5)
New comment
Thank you Gargav.
Still in time:
How can I read a step error?
For example:
If Step2'TMO overshoot, how can I stop the sequence so the operator is forced to start it again?
Thank you.
Rank: 3
on
9/2/2012 11:54:36 PM |
Like (0)
|
Report
Hello, Sorry for delayed responce.
You can go to Edit>SFC parameter where you can configure alarm with priority and message upon overshooting TMO. and other access level with SFC to deal with operator level, Hope it helps to you...
Hi Gargav, I'm not finding how to configure the action of the sequence in case of a TMO overshoot. What I wanted to do is, when the overshoot occur the sequence must stop and be ready to start again.
And one more thing, when the sequence ends with no errors, I do not want it starting again.Do you know how to do this?
Thank you.
Rank: 3
on
9/5/2012 8:21:28 PM |
Like (0)
|
Report
Hello Willians, I am also not sure about this and may be you can use variable configured in 'TMO state' (go to Edit>SFC Parameter>Variable tab) and that variable you can use in next transition to take decision to jump to initial step. And regarding restarting sequence after sequence ends may be because of sequence is jumping to initial ! or I is it by default after healthy execution of sequence it restarts from beginning!
Add new comment 
Add new comment