Order to delete SB2.1 AC800M libraries
I'm upgrading a SB2.1 system to 800xA 5.1FP4. I now have the system upgraded to 5.0SP2 and to get a clean backup without errors I need to remove the 1.0 version of the AC800M libraries. But as there are many dependecies this needs to be done in a certain order. Does anyone have this order so I don't have to find out by trial and error?
Thanks in advance.
Voted best answer
Unless you are able to figure out this yourself, your regional ABB support center should be able to assist you.
As I have posted earlier on this forum, I promote this action. I.e to purge older libraries out from the system following an upgrade - why keep tons of older generation of VB6 graphics in your system when using a more recent version, or even PG2?. This "ballast" that will make your backup/restore to crawl rather than run, possible also cause warnings and errors...