Advant Controller - Post Mortem Analysis
I try to use Engineering laptop ES140 Station to connect to offline testing AC450 by Post Mortem Analysis mode.
RTA board (PU516) in ES140 was connected to service port (X11) in front of AC450 (in OFFLINE “-4” mode). Then I started Online Builder software locally in ES140 then choose Command Sets “Advant Controller 400” then “Post Mortem Analysis”, the command set change to LOCPSET CMDS: DEAR310A.CT, then #COSESS to connect but not successful, it show
I have tried to reboot Engineering board and depress Mode button in AC450 to bring to OFFLINE mode few times but still not connect.
Can you give me any advice?
Voted best answer
Please find the file, which we have prepared for Post Mortem Analysis for faulty AC450 controllers
Incase once again if the controller went to fault mode, please execute the below attached file and send us the error file for the further analysis...
Steps to execute the file:-
1. Copy and paste the post.cf file in C:\Proj\XXXX\Nodes\AC1\ SRCE folder.
2. Put the stalled CPU's switch in offline and INIT the system. It should come to " -4 " state.
3. Connect the PU516 directly to the CPU using the direct port (not the MB300 port) using TK624 cable..
4.Go to Online Builder -Select Command Sets --> AC400 --> Post Mortem Analysis menu option.
Then Execute the below command...
Copy the bold text and paste in Notepad and name it as Post.CF and execute.
i hope it will be useful.