Microscada control panel not starting version sys600 9.2sys
we have loaded the 800xA 5.0 sp2 ru1f (single node setup with AS-DC-CS) and on top of that we have loaded microscada sys600 9.2 version so on trying to start the control panel.
A pop up message saying that microscada service not started.
[serv]An access error occured.check password or permissions for microSCADA 
Given rights for the allow logon locally to the administrator user and tried but ended with same result.
could anyone faced the same issue let us know the solution
Did u install MicroSCADA lic? During installation of MicroSCADA it creates new user. Dont change that password after installation else it wl not start.
Try to check for all hot fixes from below link.
Below link for temp lic and reference docs: