HART Communication Error: TRS Error -1 / TRS Panel Error -5
I have 5 controlers in a Project, 3 then are properly communicating with HART devices however, im having trouble with the other ones.
Communication is properly enabled but, when I perform any HART requisition or try opening Observe in DTM, I receive error HART Communication Error: TRS Error -1 and in TRS Panel I got Error -5.
Tool Routing Service is enabled in all controllers.
System 800xA 5.1 FP4 RevD RU2
Do you have any tip?
Answers
This question has not yet been answered.
Add new comment