loading parameters in commisionning mode
I changed some parameters when my CPU was running (for example a PID). The changed parameter is after in yellow.
But when I come back in "configuration mode", these changed parameters don't appear.
Do we have a solution to definively charge the new configuration in the CPU ? Because for the moment, the only solution is to note each changed parameter in commisionning mode on a paper and after rewrite each parameter in configuration mode. After, I reload the CPU...
Voted best answer
Of course. Go online (Commissioning mode), open "Load" menu and choose "Parameters...". Then choose Parameters that You would like to correct in Your project by means of "Parameters" and "Search Criterion" groups and selection in the list below and click "Correct" button. That is all.
Also remember, that if You change any parameters in commissioning mode, You can choose to "Correct" them instead of "Write". Writing changes the value only in CPU. Correcting changes value in CPU, but also in project.
Hope this helps,