PM590 ETH PLC IP problem
Sourav i want share one issue with you ,here i`am using PM590 ETH with Codesys 2.3 and DigiVis500,everything is working smooth untill and unless whenever the controller i.e PM590 ETH is some how turned off ( although the power supply is provided with UPS ) the IP address of the controller got washed off( the battery is checked and working properly) means its reset to 0.0.0.0 which earlier i set as 172.16.4.5, even for checking purpose when i turned off the controller poer the IP address got vanished,wanna tell you that i also did the Create a boot project in the POU structure,but not helpful please tell me what should i do??
Voted best answer
In Codesys 2.3 for setting the IP address of the controller permanantly you have to use a tool called "SYCON". This will be available in Codesys software and while installtion you have select SYCON also.After installation it will come under "resources"--> Tools--> SYCON.
Once you open the tool there you to set the IP address and Subnet mask of the controller.
For Detailed steps to set the IP address using SYCON refer Codesys Manual.