Turn off TTD Logs in AC450 controller
Can you to turn off TTD Logs (not just variables) without taking the controller to configuration mode, e.g. by killing and starting tasks, using lower level database commands etc.? MDB only lets you turn off the logs on configuration mode. The logs are no longer in use and all variables have been de-activated since logging is now OPC logs from an 800xA system. Controller SW version:
Voted best answer
This can been done and also reversed in full production.
Note that you may have to repeat the KIT until you see the task abort system message (tasks with auto start option enabled will survive two, but not three consecutive KITs).
Then use FINS/GINS/MPRO to disable the TTDLOGs in the database, or else, the logging will startup again at next warm start.
ACT DCTA100 can be used to startup the three tasks above in case you want to revert.