A0845 Redudant Card one of the card goes to fault_
We have in site 800XA 5.1FP4 , PM866 Controller connected to second clustor with 6 redudant set of AO845 cards, 6 channels are used in all cards.
In this configuration one of the card is always going to fault. If we remove the faulty card and insert it back it will come with healthy status , but after some time the card will go to fault mode again.
Cable specification - Distance (550 Meter ) , Thinkness - 1.0 mm2 , NIS cable
Can you please suggest the solution or any one faced similar issue before.
PM866 controller is redundant?
In many case is the redundant configuration go to bad it's because there is an issue on the optic fibre.
I have an example with a redundant controller configuration, the redundant controller is going all the the time to fault. The solution was to change a defect optic fiber.
Verify all your fiber network.
Please check same question