800xa Bulk to diagrams in control builder 800xA version 6.0.2
Is it possible to bulk to diagram in version 6.0.2. I have a system running and I can read data to the BDM Excel sheet, but I cannot write again. Is it correct that this function, is not supported in version 6.0.2 and if not, when will this function be available?
Is there a work around?
Jørn Møller Sandbæk
It is not possible to use ordinary bulk data manager to write data with Excel together with Diagrams. It is still possible to read properties and so on.
This is nothing new to V6.0.2, it has been the same since Diagrams were introduced. If the code is programmed with Control Module Editor it is still possible to use ordinary bulk data manager to do bulk job.
Have a nice day.
Best Regards // Mattias, AB Tändkulan Sweden