When my program is RUNNING, after some miniute(about 5 minute),progeam gives WATCHDOG error and CPU goes to STOP
whats my problem?
HELP ME\\BEST REGARDS
Voted best answer
If you are on CPU firmware older than 2.4.2, the project without task configurations use the "DefaultTask" (Prio=10, Type=Cyclic, Cycle time=10 ms, Watchdog=On, Watchdog time=10 ms, Watchdog sensibility=1).
This can lead to trigger the watchdog especially on small PM5xx.
With Firmware 2.4.2 and above, the project without task configurations use the same "DefaultTask" but the watchdog are longer and sensibility are larger.
Do you have any task configured ? there if watch dog is active(should be kept active) and execution of task is taking longer time then configured watchdog will get triggered. Check image below and make sure watchdog time should be greater then interval time atleast 30-40% greater.
and sensitivity you can configure 3(if configured watchdog time exceeds no. of time it's allowed and watchdog will not get trigger)
This is as per my understanding, seek second opinion....