How to bypassing a ACS800 drive from control builder.
Is it possible to bypass a drive (ACS800)from control builder i.e. from the Controller hardware connection defined in the modulebus node.The drive is being communicated through optical fibre.
Is their any other means. Some status word & actual data of the faulty drive is required to run the entire line.
Voted best answer
It depends on your application.
Most probably you can "forse" some status of the drive in order to receive a ready to start the complete line.
Most probably you need to give some feedback - the drive is running after start command, so you will need to create some small logic for that.