Speed Reference DCS800
You helped me six month ago. I was able to connect DCS800 with AC800PEC.
The thing is that I followed your instructions but I cant write a Speed Reference.
Im forcing the channel where the speed reference is, and the motor dont change speed.
Im working with DEMO DCS800.
I did send you the parameters that I have on Drive Windows Light.
I hope I dont disturb you.
Thanks so much.
Not aware of your previous discussions with Zeeshan. But If you want the Drive to work the correct way is through the Command Word. Here you can enable to the drive to work and then you can write the Speed reference setpoint as long as this is correctly in range. You can read the status of the drive through the Status Word. If you believe all is ok, check the interlocks on the demo set, perhaps the switch for local use is enabled.