Tab Navigation is not Working.
We have 800xa 5.1 FP4 running on our system.
The tab navigation workplace was configured according to the manual, but the tab navigation area is blank if you open the workplace.
When click on the tab aspect with main view on the workplace structure "Unable to locate base pane".
Double click the tab aspect opens a new window " Tabs cannot exists in overlaps, it need a base pane".
In the screen layout code matches the one shown on the operator workplace configuration manual.
The configured root is having a graphic display.
Any valuable suggestion would be appreciated.
Voted best answer
Apart from what Arihant has said, it could also be due to a missing PG2 aspect.
In Functional Strucutre, where the various tabs are defined under the Root, ensure that each tab has a corresponding PG2 graphic aspect. This will allow for the Tab to work.
There are some panel configuration changes done as a part of FP3. The pane name should be changed to from name="idBase1 to name="Base1". The tabbed workplace works only when the base name starts with "Base". Also if the navigation root is changed in the TabGrouping aspect, the same should be changed in src attribute or the src can be like src="" so now changing the navigation root alone is required.
The tab grouping aspect Mainview always shows "Unable to locate base pane" - Ignore this message. Config view is important and used for the tab grouping configuration.Is the Tabbed workplace working fine? If so, then no problem.