Set maximum and minimum value in 800xA trends
Voted best answer
The system will try to read these attributes (min, max, decimal count and engineering unit) from the Control Connection aspect (in AC 800M called Function Block or Control Module).
Study the Control Connection aspect's tabs - especially the Additional Info tab.
In AC 800M, RealIO variables have this info automatically embedded - study the RealIO data type in Control Builder M.
An alternative is to use a Property Extension Info aspect which can be added on an object type and configured similar to a Control Connection aspect.
Last; the Log Configuration aspect can also be set with this info, but then it will be static.
I m also facing the same type of problem with the version 6.0.1 (MOD connect)(6.0.0 updated to 6.0.1). In object strucuture i was used trend display and if i change the min and max to 0.0 it will not take the values. and we have to set some ranges only.
And automatically it will take the ranges of -100 to 0.
As per the release notes if 6.0.1 it was cleared from 6.0.0. But still i am facing the same problem.
Kindly suggest me....
Thanks and Regards