How to start up CPU PM802F
I have new CPU PM802F and sofware Control Builder F 9.2 SP2,
could you help me to start up it?
When i connect power supply (SA811) and Lan cable with FI 813,but Failure led on module SA811 red blinking light
pls help me
Thanks for your support
Voted best answer
Hi, Check few things
Power supply SA 811F monuted properly ? means is it locked ?
Power supply is getting proper voltage ? check with mulitmeter at power supply terminals.
Check on E1 slot ethernet module EI 813 coding switch is not set to 0(zero), set it for required IP address. e.g 5 for 172.16.1.5
Check EI 813F is also inserted properly and locked ?
If you are trying to set different IP address then default one i.e not 172.16.1.xx and you have connected diagnostic cable to set ipaddress, then run/stop switch should be at "STOP' position otherwise - Failure LED will blink.
If all above things are ok. Recomended to follow 3BDD012501R0501_M&I_AC800F and reply back if it's not starting.
Hope that helps