What is the data transmission rate of PM861 A controller? How it will check?
I want to send signal to from PM861A redundant controller to other DCS through optical fibre.But i dont know the transmission rate of signal from PM861 A
a.How it will check?
b.Which type of media converter is compatable with AC800M controller?
Now i am using phoneix ethernet switch with optical fibre slot?
Thanks in Advance
The controllers range PM85x to PM86x supports 10MBPS half duplex (except PM891-100MBPS Full duplex) so highly recommended to make the fixed setting for controller network ports where AC800M is connected as Half duplex-10MBPS.
Avoid mixing the different speed in the same switch to increase the performance
Note:Don't use autonegotiation for the controller ports since autonegotiation, since as combining Connecvity server running at 100MBPS full duplex and controller at 10MBPS off course both should be connected to the same switch in that case always use port settings in the switch as for controller (PM85x to PM86x)-10MBPS and CS-100MBPS full duplex don't make it autonegotiation since it may cause network performance issues even though it work fine.
Generally you can check this by transfering any big files(approx 1GB) between the network with 10MBPS/100MBPS on both side then observe the time taken.
I have executed projects with Phoenix it quite works well i think media converters won't play big role here...
Always look at the speed the both ends supports.
What is in the other end?
How do you communicate with it?
Other vendor, custom TCP or UDP protocol?
The first uses the built-in 10 Mbit/s half duplex copper Ethernet interface of AC 800M
MODBUS require a CEX bus communication unit, I believe eg CI867 have 100 Mbit/s Full Duplex (not really sure though)