Network Acceptance Measurement - CN 37-046 EN
- During acceptance measurement the following network properties are checked:
When the physical properties are checked, the following faults can be determined:
- faulty cables, improper installation, bad connections
- grounding problems
- interference pick-up, crosstalk, noise
for coaxial, fibre optic and twisted pair cables.
Network Analysis (optional)
Online check of the quality, smooth operation and data throughflow of the network
Network documentation (optional)
Recording the entire network topology with all addresses and devices
Please contact our Service Network Support in advance on the following telephonenumber:
+49 1805 123 580
To prevent network faults the installation of DigiNet S should always be completed with an acceptance measurement procedure and acceptance log as described under point 5.2.2 of the Mounting and Installation Instructions for Digimatik. Acceptance measurement in accordance with defined test standards is the state of technology for Ethernet Standard IEEE 802.3 and ISO/IEC 11801.