at one of our plants with MB300 advant network I get frequently system messsages that i can't found in documentation. It is like:
12 76 *09:46:03 24 16 DCBAG00 H'0304002 18 H'000C002
12 76 *09:46:03 24 16 DCBAG00 H'0304002 18 H'000C001
The network number is 11/12 the node number 1 and 2 are old OS which we have removed. I have also removed these numbers from all of the controllers, the status is clean (green) but still these messages occur from time to time.
Has anyone an idea?
Voted best answer
This is one of the most common system messages, all categories in Advant Master...
24 16 DCBAG00 = an alarm or event is not possible to deliver to a member of the MasterView Table, MVT. The missing member is seen in hex in data 2.
Each RTA and MV will automatically "push" itself into the MVT of any controller it sees to start subscribing for alarm and event.
This problem occur if an RTA or MV is removed from the network. The MVT is only rebuilt during warmstart of Advant Controller 400. MasterPiece 200 need cold start.
The problem is easily corrected using the Expert Command processor, available on Advant Station and AC400 CS RTAs.
# SLLEV SYST
* LOCPSET CMDS:TP02.CT
Use OMVT-menu to LIST content of MVT, then *with care* use DELETE to remove nonexistent RTAs. Use LIST again to verify the deletion was successful.
Deleting a existing RTA will cause the current controller to stop sending alarm and event to that RTA. If you by accident remove an existing RTA, either use INSERT command to insert it again, or restart the Advant Station/AC400 Connectivity Server to automatically correct the MVT.
Warning: Use these tools with care, or else you may miss an alarm...
I have used this command set but then the DNOD ne,no command to remove the nodes 1 and 2 from the MVTAB of all the controllers.
*SLTARG x,y (all controller nodes)
Afterwards all the controllers are "green" in Status. All the PU410 in the whole system I have rebooted.
Is that command different from the OMVT/DELETE option you suggest?