Blank Fielbus Management Aspect
I am trying to establish HART DTM communication through AI815. All the required system extensions are loaded and DTMs installed. I am able to add Device under AI815.
The problem is with Fieldbus Management Aspect. It is showing Blank. When clicked, it gives following error message
" Run-time error '91': Object variable or Width block variable not set"
I checked the following case for help. The issue is at same location:
I am unable proceed futher.Please Help
If user not performed post instalaltion steps for Device Management PROFIBUS HART, then it may result in Blank Fieldbus Management Aspect.
All Post installation steps for Device management PROFIBUS HART are automated from 6.0 .
Run below Post installation steps .
1. Run "FBConfigureComponents.exe" as Run as Administrator
Installation Drive:\Program Files (X86)\ABB Industrial IT\Engineer IT\Fieldbus
2. "PHDTMUACUtility" as Run as Administrator
Installation Drive:\Program Files (x86)\ABB Industrial IT\Engineer IT\DTM\Basic HART DTM\bin
1. Please close Workplace before performing above post installation steps
2. For 32 bit OS: File location shall be changed as “C:\Program Files\......”