MOD 300 Alarms doesn't works works
I'm working on a upgrade project from 800xA SV5.0 Rev D to SV6.0 and i have a MOD300 DCN ring. I connect my new connectivity server to this ring and the OPC DA works correctly but for some reason the OPC AE doesn't. I can't see alarms on faceplate or alarm list. The event collector service for MOD300 it's on service status and correctly configurated, I try whith an Upload but i still whit no alarms.
Use third party A/E viewer to check if alarms are actually being generated.
Also check in Event collector Service provider status is DiscardedAlarms are zero. It should be zero. If not zero then alarms are being lost. use afwapplogviewer to find why alarms are lost.
Attch screen shot of your Event collector configuration.
I've done an upgrade from SV5.1 FP4 RevE to RevD with MOD300 Software, and the OPC AE doesn't work.
To make it working, I removed the "PAS - System Services" & the "MOD300 Connect" softwares on the 2 connectivity servers. After that I installed MANUALLY exactly the same software (PAS & MOD300 Connect) and it was good.
Perhaps the automatic way to install MOD300 software in not fully operational.