OPC Datalink replacement
In our install base we are using OPC datalink 1.2 to transfer data between IEC61850 connect server to AC800M . We have total 2100 tags which are non crytical.
Is there any way to get rid of OPC Datalink as this is thirparty software and use some inbuild function of 800xA ( Property tranfer)
Property tranfer is used in 800xa 5.0 system in other site which faced lots of issue wiht update and even some service freezing . 800xA 6.0 is there any difference in performance or any other methode to do same job?.
There are several known problems with Property Transfer in 5.0 that would cause the services to stop, memory to creep etc. AFAIK these were resolved in version 5.1
However, IMHO Datalink is a much more reliable and easier to configure OPC Bridge than the Property Transfer service anyway. If you cannot get an answer from ABB about a new version of Datalink then you could try this one instead ...