Connect via connectivity server
Control builders IP is 192.168.1.87. Connectivity server have two network card (192.168.1.20 and 192.168.10.1).
Controller have IP 192.168.10.2
I think that Explicit RNRP is configured, because EngClient can see all structures of aspect server. I turn "Enable TCP/IP forwarding" on ASCS and restart it. But if i try in control builder Right mouse click on Сontroller-Remote system i get message "Error in communication link to system 192.168.10.1"
Whether it is necessary to configure explicit tab RNRP wizard for network adapter of control network (192.168.10.2)?
Voted best answer
Though u are using Class C Ip range with subnet /24 of defferent network ID for the client server(EWS:192.168.1.87/24 so host id:87 and CS:192.168.1.20/24 so host id:20)
control network (192.168.10.1/24 so host id:1this you make it as 192.168.10.20 since CS should have the same nodenumber for both control network and client network as well and 192.168.10.2 so host id:2)
so here in for EWS and CS and controllers you have to perform
1. Change the Base parameters:
Base address (implicit addresses) to 172.20.0.0
Number of used explicit addr tabs should be increased by 1 to 2 if redundant network for EWS and 2 -4 for CS since it has 4 networks
2.In the explicit tab1 define the IP address primary network then path=0 and node number =host ID as 87(ews),20(cs), network area=4 (you can select your own network area between 4 -31).
3.In the explicit tab2 define the IP address primary network then path=1 and node number =host ID as 87(ews),20(cs), network area=4 (you can select your own network area between 4 -31).
same for other tabs as well.
4.For controller in ethernet settings define your node number,path and IP address
then restart the CS and EWS and download the controller for hardware changes.