Enable Overrride..Supervision library
I couldn't override the GTHH by slecting the InhibitGTHHAct...selection is graded out...I have selected the overrride control...does I missing anything ?
Note that everything working in site machine...I am trying to simulate one problem at site...but in my virtual machine I couldn't sleect the InhibitGTHHAct...I have restored the full backup from site to my virtula machine...please go through the attachment...I am not a safety system expert....please advide...
(Discalimer: Im not an expert on the Supervision Lib either )
Your application is connected to IO - which can cause all sorts of problems when you're trying to simulate in a Soft Controller, even with Hardware Simulation enabled. Thats where the Yellow blocks on the top left of the faceplate are coming from.
Typically when I'm trying to simulate a process I disconnect the IO from the hardware entirely. Then you can also write another small program to simulate the IO signals if required.