system 800xA Health check
on my job used ABB Advant OCS System with master software and Advacommand 1.7 for Windows NT for control and monitoring.
a couple month ago upgraded ADvacommand 1.7 to System 800xA for advant master.
Installation and Configuration of System 800xA Software Done by Non-Experted personal.
so please some body say to me how much i must worry about this issue.(Installation, Configuration and Commisionning of System 800xA done by Non-Experted Personal)
how much important that need the System 800xA Health Check Done.
which problems may be occured for our control system if Bad installaion and configuration done by Non.Experted personal
Bad installation can be major source of problem. It is recommended to do a full health check on system. However to begin with you can use Diagnostic collection tool. This tool presents very nicely all the installed software in each node in system in Excel and you can compare the installations between each node.
Make sure all the system extensions are consistently installed in each node.
Unfortunately, installing System 800xA is a rather complicated process. I recommend that only appropriately trained & skilled personnel is used for this very important task.
If the persons that performed the installation are truly "non-experts" as you write there is a moderate to large risk that the system is not running with optimal settings, or with a configuration that is not fully supported. But I won't pass any judgement on your system, you can succeed pretty well if you know what you are doing and read up on the documentation.
In any case, I sincerely recommend performing a full, *manual* System 800xA Health Check possibly assisted with scripts after any new installation.
The full/manual health check is not to be compared with the Benchmark, Fingerprint and to some degree Service Data Collector tools/services which offer semi or fully automated checks. Such checks can find problems on the surface of the system, e.g. a full hard disk or an improper network setting. To be able to find problems in the inside of the system, a properly skilled person must do the manual health check parts, and do them well.
The output from all automated health check tools must be properly filtered before put in a final report, e.g. why put a full client hard disk on page 1 of the report if the system is suffering from crashing services and poorly tuned parameters on the inside?
To perform a System Health Check, the person should have attended the E144 Expert Workshop and have vast engineering & field experience of System 800xA.