How to configure ACS560 Parameters for Frequency up/down using Push Buttons??
I have ACS560 VFD and I want to run the application as below
DI1: Start Command
DI2: Jog Command
DI4: Speed Increase
DI5: Speed Decrease
I have done following settings
20.25: I am not getting what to set, it is now at factory default.
Other than this parameters which parameters I have to set?
Thank you in Advance.
Voted best answer
Seems you have to use motor potentiometer function.
Easiest way is to set 96.04 = Motor Potentiometer
Then read macro description page 111....
DI1=Start (1)/ Stop(0)
but you can modify the default application macro settings depending on your needs.
E.g. to have a separate start and stop inputs, use 20.01=4.
Source: ACS560 standard control program Firmware manual, 3AXD50000044997 Rev H