Error In Backup: Failed to Serialize itself
While Taking Control Structure Backup getting this Error "Aspect Failed to Serialize itself"
Please help me out to Solve this Issue.
System version- 6.0.3-2
Perform a consistency check and try to correct the inconsistencies. If it not find any error, or fail. Check the behavior of the aspect in the system to make sure that it works as expected. These are often aspects with size = 0.
If all looks ok try to exporting from another node in the system. If no node can successfully export the project it is likely corrupted, somehow. And I suggest to create a support case with your regional ABB support center.
If the troublemaking Application aspect belongs to AC 800M Connect (i.e. is a Control Builder M application) the application is likely damaged and you should take immediate action to not loose valuable work.
Consistency Check / Repair will likely not succeed (however, I will not shut the door on that tool being able to correct things).
NOTE: Be very cautious and always export (if possible...) before attempting any repair. Today a disk snapshot or virtual clone may serve as a temporary solution. Control Builder M can also save in Compact CB format enabling you to attempt saving your precious work in a less complex format, that later can be (with some effort) be restored back into the 800xA control project.
Eventually, you may be forced to restore (import) a known good backup of the application. A complete System Restore is also an option, but much more intrusive since it will bring everything down, likely for hours.
You may elect to ask your regional ABB support team for assistance.