AC 410 DI card repeated fault
What could be the reason for same cards (DDSDI110N )of redundant controllers to went into fault repeatedly?
Problem disappears after re seating, but appears again after some days. The cards of both redundant controllers were changed, but problem still persists.
Problem disappears after re seating, but appears again after some days. The cards of both redundant controllers were changed, but problem still persists.
Voted best answer
Keep the online builder connected at all time to fetch the system messages on the ONB console when the problem occur.
This board is used in Safeguard 400 only, check the safety system MMCX for related safety alarms.
Contact you local ABB Support in your region, If you are an ABB employee, contact ABB L3 Safeguard Support in Norway.
Best Regards Jan-Erik
This board is used in Safeguard 400 only, check the safety system MMCX for related safety alarms.
Contact you local ABB Support in your region, If you are an ABB employee, contact ABB L3 Safeguard Support in Norway.
Best Regards Jan-Erik
by kstoilov
Hi,
I'm sorry, not my cup of tea
by Jan-Erik Rask Rank: 82 on 12/10/2020 12:14:10 AM | Like (1) | Report
Keep the online builder connected at all time to fetch the system messages on the ONB console when the problem occur.
This board is used in Safeguard 400 only, check the safety system MMCX for related safety alarms.
Contact you local ABB Support in your region, If you are an ABB employee, contact ABB L3 Safeguard Support in Norway.
Best Regards Jan-Erik
Add new comment