ACS5800 Transducer help
I'm getting conflicting information of setting up a THREE wire pressure transducer. Can someone please assist.
Single unit running a 5HP submersible water well pump. Input two wire single phase, output three wire three phase.
1) Where do I connect the three wires from the transducer.
2) how many jumpers do I need?
3) What do I set the dip switched to.
Sorry but I have been seeking information but so much of it conflicts with other information and most show only TWO wire transducers.
Single unit running a 5HP submersible water well pump. Input two wire single phase, output three wire three phase.
1) Where do I connect the three wires from the transducer.
2) how many jumpers do I need?
3) What do I set the dip switched to.
Sorry but I have been seeking information but so much of it conflicts with other information and most show only TWO wire transducers.
Asked 6 months ago
Answers
0
Hi
probably you are referring to ACS580 drive, ACS5800 AFAIK not exist....
However, if you need the connections of a 3wire transducer, you can see below:
No jumpers are needed
Please read carefully the FW manual, IMHO you can find the complete suggestion for your application
Hope this help you
BR
Flavio
probably you are referring to ACS580 drive, ACS5800 AFAIK not exist....
However, if you need the connections of a 3wire transducer, you can see below:
No jumpers are needed
Please read carefully the FW manual, IMHO you can find the complete suggestion for your application
Hope this help you
BR
Flavio
Source: ACS580 FW MANUAL
Add new comment