Implementation off / on controller using step controller C_SS in Freelance
I try to make a simple control of heating cables. The heating system has a time constant that we assume will be about 0.1degree/min according to the supplier. This means that a sensible regulation will be deadband control, says the supplier. Behavior: The system switches on when 0.5 degrees below the set point. The system switches off when 0.5 degrees above the set point. Thus, I thought, if it is possible to use a step controller (C_SS) How should I configure this, as there are alot off parameter settings in the C_SS block (As we speak, I read/trying to understand this block)
What kind of parameter settings do I need to get this to work?