Not able to Read the data in HMI from Drive
Recently i working on Communication between ACS560 Drive & ABB HMI ( CP607) through (RS485) Modbus RTU, Communication is Healthy fine. From HMI when i trigger the CW, then drive is starting in Remote Mode & Frequency also i can able to write to drive from HMI. But i couldn't read the motor output speed in the HMI.Same when i connected with Modcan 32 bit software at (modbus Address 40006 location) i can read output speed of drive.can Someone tell me what is reason ? The Address which i given below attached , Including the drive parameters settings.In HMI at ACT1 & ACT2 i can read the same values,but respective holding address as 400005 & 400006. Is there any parameter settings need to changed in Drive. Please help me to sort out this issue?
Thanks in Advance.
This question has not yet been answered.