Making a new alarm in CHMI
Dear sir
I am using CHMI 6.0.3.2 and a newbie
when output is high it should make an alarm
Please share doc to do this as a beginner
thanks
I am using CHMI 6.0.3.2 and a newbie
when output is high it should make an alarm
Please share doc to do this as a beginner
thanks
Asked 7 months ago
Answers
0
Hi,
You can use Soft Alarm in 800xA, first the respective service should be up and running.
1. Add "Alarm Expression" Aspect in the desired place
2. Configure the Category, Condition, Priority, Message and expression (logic) as shown below.
One Example:
You can use Soft Alarm in 800xA, first the respective service should be up and running.
1. Add "Alarm Expression" Aspect in the desired place
2. Configure the Category, Condition, Priority, Message and expression (logic) as shown below.
One Example:
Answered 7 months ago
2
In control structure click on signal > click on alarm Event configuration aspect > go to Alarm tab & enable > then go to Event tab > check is an event > select text group > check override default condition name > Enter your Conditions Description > apply > ok
Answered 7 months ago
Add new comment