CM574 configuration with PM573 PLC
Configuration Screenshot attached for reference.
i have downloaded program to CM574 and did create boot project, then i downloaded program to PM573, when i click on run mode of PLC, its showing 'E4:Ext 2.CM-574-RS Program not started because of configuration error'. because of this whenver PLC power recycle happens, my PLC will go to stop mode. i need to do diagreset manual and proceed ahead.
also in modbus im receiving 12289 (No CTS during transmission).
can youhelpme out on this.
I think the error is implicit in your question: if the cpu replies that there is a parameterization/configuration error of the CM574-RS, I think you need to check how this board has been configured at the Automation Builder level. I have never used it yet, but I think the online help may contain some more information, there may be an attribution conflict.
Pay attention that the problem is not related to the warning signal you posted: a functioning is not defined for the Modbus protocol.