ACS600 CURR MEAS FAULT
Please I have ACS600 which was giving me overcurrent fault so I was advised to change the igbt. After changing , its now giving me CURR MEAS. I DINT KNOW WHAT THIS FAULT IS.
PLEASE WHAT SHOULD I DO
PLEASE WHAT SHOULD I DO
Answers
Please refer this to your local ABB drives expert, as it looks there is something else going on.
Hi
ACS 600 is a rather old drive, an overcurrent indication may be due to an IGBT failure but also from other causes that should be better investigated. A current measurement fault indication can indicate a problem in the current transducers but also in the control board, which receives the signal.
So I suggest, as you have already been told, that you contact your nearest ABB distributor or better still, the ABB Service who will be able to best support you in solving the problem.
BR
Flavio
ACS 600 is a rather old drive, an overcurrent indication may be due to an IGBT failure but also from other causes that should be better investigated. A current measurement fault indication can indicate a problem in the current transducers but also in the control board, which receives the signal.
So I suggest, as you have already been told, that you contact your nearest ABB distributor or better still, the ABB Service who will be able to best support you in solving the problem.
BR
Flavio
Add new comment